|
Cuemakers
Supplies
-Sanding Arbors-
|
Cue Maker uses these products when creating his cue as
shown below:
HARDENED STEEL SANDING ARBORS
58 Rockwell Hardness
Ever wonder how cue makers get a perfect shaft to cue match
every time?
This is the most needed tool for both new and accomplished
cue makers! It gives a perfect match* on both shafts and
butts in mere minutes!
These are two-sided sanding arbors. They work on both the
butt side and the shaft side. The arbors are constructed out
of a 58 Rockwell hardness steel sleeve, with a brass inner
pin holder. The thread sizes available are 5/16-18, 5/16-14,
3/8-10, 3/8-11 and 3/8-6. The diameter of each arbor is .845
*Your lathe must be properly zeroed in for
the perfect match.
|
 |
 |
 |
 |
5/16-14 - $60.00
|
5/16-18 - $60.00
|
3/8-11 - $60.00
|
3/8-10 - $60.00
|
|
|
 |
 |
 |
 |
|
Butt End- $35.00
|
3/8-6 -
$60.00
|
Uni-Loc- $85.00
|
6 Piece Set - $295.00
Including Uni-Loc
Priced Individually - $385.00
Savings of $90.00!
|
|
|
|
 |
|
7 Piece Set - $340.00
Including Uni-Loc
Priced Individually - $420.00
Savings of $80.00!
|
|
 |
Aluminum Tenon Threader 5/16 - 18
$32.00
|
***SPECIAL NOTE***
Need smaller sizes? We can custom make one
with a set-up fee of $75. Call us for more details |
 |
